Weight distribution can help reduce sway when towing but it does not always stop all of it. The best solution would be to move any weight in your trailer forward to increase the tongue weight and also make sure the trailer is sitting as level as possible.
Or you could go with the Curt True Course sway control part # C94VV which has a sensor that can detect when your trailer is swaying and applies enough brake to stop it. view full answer...
Nice question, lets find out below:
First we need to make sure that you have the right fit.
Measure from the ground up to the door frame and then measure the width.
**TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 3 Steps - 375 lbs - Black Bracket # TLA7833.
This unit listed above fits entry heights 23-1/2 to 34-1/4 inches tall.
The mounting bracket needs an area right under the entry door that is 21-1/2" wide x 12-1/2" tall x 8-1/2.
Here is a list of the basic mounting... view full answer...
We don't have an install video but what I can do is describe it. The portion of the # LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width of your steps. Then the square hole side of the outrigger is used to run the included hardware through to attach to the step. If the mounting hardware from your old steps is too rusted or damaged then you can use the hardware kit # LC118155-72 for installation... view full answer...
The outer brackets (hexagon heads) have changed with the Solera 5000 Series slide toppers so you'll have to slide them off of the inner brackets to install the Solera RV Slide-Out Awning # LCV000165062. You can leave the inner brackets mounted to the wall of your slide out and simply slide on the new outer brackets to get the slide topper installed.
On a side note, It looks like you might have slightly too big of a slide topper on the slide out and it's causing too much tension on the... view full answer...
The Automatic Changeover RV LP Gas Regulator # 37207-30395 will indicate RED for an empty tank or if it does not detect propane.
If you have your tanks turned off it will stay red. When you turn a tank on the valve indicator will turn green. It does not read both tanks at the same time, It will only tell you the status of the tank that the black lever on the top of the unit is switched to.
I have linked a video guide that will show you this in real time and explains the process. view full answer...
Go To Results